Install right output shaft
NOTE:
The figure shows the procedure for the front axle differential. The procedure for the bearing bracket is identical.
- Fold open the assembly protection ring (1).
- Guide in the output shaft (1) in the arrow direction into the bearing bracket but do not
let it engage.
- Pull the lug of the installation protection ring (2) until one of the two predetermined breaking points yields.
- Pull out the installation protection ring (2) and dispose of it.
- Insert output shaft (1) up to the stop in the bearing bracket.
You must be able to feel and hear the output shaft (1) engage.
Follow-up work
- Refer to POSITIONING THE OUTPUT SHAFT, RIGHT, AT THE SWIVEL BEARING .
- Refer to PLACING THE OUTPUT SHAFT, RIGHT, TO THE SIDE .
- Refer to FITTING THE WISHBONE, RIGHT, AT THE SWIVEL BEARING .
- Refer to DRAINING AND TOP UP THE FRONT AXLE TRANSMISSION OIL .
- Refer to FASTENING THE OUTPUT SHAFT ON THE WHEEL BEARING .
- Refer to SECURING THE TIE ROD TO THE RIGHT ON THE SWIVEL BEARING .
- Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
- Refer to INSTALLING THE COVER OF THE STEERING ASSEMBLY ON THE RIGHT .
- Refer to INSTALLING THE FRONT RIGHT WHEEL .