Remove the connecting bracket of the exhaust turbocharger for the cylinders 1 to 3

Preliminary work 

• Refer to REMOVING THE FRONT UNDERBODY PROTECTION .
• Refer to REMOVING THE TOP RIGHT AND LEFT COVER IN THE ENGINE COMPARTMENT .
• Refer to REMOVING FRONT CROSS CONNECTION .
• Refer to REMOVING THE LEFT AND RIGHT FRONT-END STRUT .
• Refer to REMOVING THE ENGINE COMPARTMENT COVER PANEL IN THE REAR LEFT AND RIGHT .
• Refer to REMOVING STAND FOR THE HOOD GASKET LEFT AND RIGHT .
• Refer to REMOVING THE REAR TOP CROSS CONNECTION .
• Refer to REMOVING FAN COWL .
• Refer to REMOVING THE RIGHT AIR DUCT .
• Refer to REMOVING CLEAN AIR PIPE CYLINDER 1-3 .

• Unlock and loosen clamp (1).
• Feed out coolant line (2) and place to one side.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Unlock and disconnect the plug connections (1) and (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Unlock and release tank vent line (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen screw (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen screws (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Guide out connecting bracket (1) for cylinders 1 to 3  and remove.

  Courtesy of BMW OF NORTH AMERICA, INC.