Install alternator
- Slightly push back the threaded support bushing (2) in the arrow direction to facilitate the installation of the alternator.
- Screw the screw (1) into the threaded support bushing (2).
- Push back the threaded support bushing (2) using screw (1).
- Once again unscrew the screw (1) from the threaded support bushing (2).
- Feed in and install the alternator (1).
- Tighten the screws (2).TIGHTENING TORQUES SPECIFICATION
Alternator on component carrier M10x75 tightening torque 38 Nm M10x125 tightening torque 38 Nm M10x90 tightening torque 38 Nm - Fasten the clamp (arrow) to the alternator (4).
- Feed in and position the positive battery cable (3).
- Tighten nut (2).TIGHTENING TORQUES SPECIFICATION
Positive battery cable to the alternator M8 tightening torque 19 Nm - Connect connectors (1) and lock.
The connector (1) must engage audibly.
- Put drive belt (1) onto the belt pulley (2) of the alternator.
- Check the drive belt for the alternator (1) for the correct fit.
- Raise the preload with standard tools (1) on the belt tensioner in the arrow direction .
- Feed out the special tool 0496 268 (11 0 390) from the belt tensioner and remove.
Follow-up work
- Refer to INSTALLING THE LEFT AIR DUCT .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING THE SEAL FOR THE HOOD GASKET LEFT AND RIGHT .
- Refer to INSTALLING THE COVER PANEL OF THE ENGINE COMPARTMENT ON THE REAR LEFT AND RIGHT .
- Refer to INSTALLING FRONT-END STRUT ON LEFT AND RIGHT .
- Refer to INSTALLING FRONT CROSS CONNECTION .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to CONNECTING NEGATIVE BATTERY CABLE OF THE SYSTEM BATTERY .
- Refer to WHEN REPLACING THE ALTERNATOR/ALTERNATOR REGULATOR: RESET GENERATOR STATISTICAL DATA .