Partially installing right output shaft

With automatic transmission only:
Lever out the O-ring (1) .
Replace O-ring (1) .
Parts: O-ring
Insert the new O-ring (1) .

Courtesy of BMW OF NORTH AMERICA, INC.
Insert the installation protection ring (1) into the radial shaft seal.
Make sure the tool fits over the lip of the radial shaft seal to avoid damaging the sealing ring when inserting the output shaft.

Courtesy of BMW OF NORTH AMERICA, INC.
Insert the output shaft (1) In the transmission.
Pull on the handle to remove the installation protection ring (2) and dispose of it.
Slide the output shaft (1) up to the stop in the transmission.
Check for secure seat by levering.

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screws (1) .

Tightening torques

Output shaft bearing to engine block
M10	Tightening torque	38 Nm

Courtesy of BMW OF NORTH AMERICA, INC.