Install the C-pillar trim panel at the bottom right

NOTE: Description is for left component only. Procedure on the right side is identical.

Install the bottom C-pillar trim panel

Check clips (1) for damage, and replace if necessary.
Check the clamps (2) for damage, and replace if necessary.

Courtesy of BMW OF NORTH AMERICA, INC.
Insert the end fitting (2) through the C-pillar trim panel.

Mount the end fitting (2) and tighten the screw (1) .

Tightening torques

End lining to body
Screw Replace screw.	tightening torque	42 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Install the carpet correctly.
Clip in the C-pillar trim panel on the bottom (3) with the clamps (2) and the clips (1) .

Courtesy of BMW OF NORTH AMERICA, INC.
Position the edge protection (1) correctly in the area of the bottom C-pillar trim.

Courtesy of BMW OF NORTH AMERICA, INC.