Attaching connector at steering gear

• To connect the connector (see the following step):

  Connect the connector with the right hand.

  The connectors can be accessed via the left output shaft.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect and lock connector (arrow) (1)  with the steering gear.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Fasten the wiring harness (1)  on the steering gear.

Courtesy of BMW OF NORTH AMERICA, INC.

If installed: Fastening the connector with the front axle support 

• Position the connector (4)  on the front axle support (2)  .
• Tighten down screw (3)  .
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Holder to front axle support
  Oval-head screw TS5 x 16	tightening torque	2.6 Nm

• Fasten the connector (1)  on to the front axle support (2)  .

Courtesy of BMW OF NORTH AMERICA, INC.