11 65 Turbocharger
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 BMW X1, 2021 BMW X1, 2020 BMW X1, 2019 BMW X1, and 2018 BMW X1. However, it is still accessible from the selected car via links, so may be relevant.
11 65 EXHAUST TURBOCHARGER WITH CONTROL - TIGHTENING TORQUE SPECIFICATIONS
| Type | Thread | Tightening Instructions | Torque Specification | |
|---|---|---|---|---|
| 1AZ Heat shield to cylinder head | B46M0/O0/B48M0/O0 | M8x12 | 19 Nm | |
| 2AZ Heat shield to trim strip | B46M0/O0/B48M0/O0 | M6x12 | 8 Nm | |
| 3AZ Electrical actuator drive for wastegate valve to exhaust turbocharger | B46M0/O0/B48M0/O0 | M4 | Screw with washer | 2.5±0.5 Nm |
| M4 | Screw without washer | 1.9±0.2 Nm | ||
| 4AZ Linkage to electrical controller drive for wastegate valve | B46M0/O0/B48M0/O0 | Tighten nut using only a second open-end wrench (to hold up). | 6±0.3 Nm |