Remove exhaust system
NOTE:
TECHNICAL INFORMATION
Mount the exhaust system in a de-energized state, following the tightening sequence from the rear silencer towards the exhaust manifold.
Mount the exhaust system in a de-energized state, following the tightening sequence from the rear silencer towards the exhaust manifold.
Preliminary work
- Refer to REMOVING THE CONNECTING SUPPORT FROM THE TUNNEL AT FRONT AND REAR .
- Refer to REMOVING THE CROSS STRUT WITH THE TORSION STRUT .
WARNING:
Hot surfaces
.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
CAUTION:
Heavy component
.
Heavy components can lead to injury or damage .
Heavy components can lead to injury or damage .
- Remove and install heavy components with the aid of another person/other persons.
- Detach the ribbon clamp (1).
For equipment specification with V-ribbon clip: Release V-ribbon clip
- Loosen V-band clamp (1).
If installed: Disconnecting the plug connection of exhaust flaps
- Unlock plug connection (1) and disconnect.
- Loosen nuts (1).
- Lower, guide out and remove exhaust system (2) with an auxiliary person.