Install the right door lock

• Attach the Bowden cable nipple (2).
• Attach the Bowden cable (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: Description is for left component only. Procedure on the right side is identical.
• Guide the door lock into the door.

  Make sure the seal from the door lock is not damaged during installation.

• Screw in screws (2) and (3) a few turns.
• First tighten the screws (2).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Door lock to door
  screw	Tightening torque	8.8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Then tighten the screw (3).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Door lock to door
  screw	Tightening torque	8.8 Nm

• Clip in locking rod (1).
• Connect and lock the connector (1) on the door lock.

  Fasten the wiring harness (2) on the door lock.

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to PARTIALLY INSTALLING THE POWER WINDOWS .
• Refer to INSTALLING SOUND INSULATION ON FRONT DOOR .
• Refer to INSTALLING FRONT DOOR TRIM PANEL .
• Refer to INSTALLING THE COVER ON THE DOOR HANDLE .