Installing the support for the lower front bumper panel
- Thread in support for the bumper panel (2).
- Tighten the screws (1).TIGHTENING TORQUE SPECIFICATIONS
Support for front bottom bumper cover to deformation element M6x30 screw Tightening torque 8 Nm
Follow-up work
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to INSTALLING TEMPERATURE SENSOR .
- Refer to PARTIALLY INSTALLING FRONT LEFT AND RIGHT WHEEL ARCH COVER .
- Refer to PARTIALLY INSTALLING THE WHEEL ARCH TRIM ON THE FRONT LEFT AND RIGHT .
- Refer to INSTALLING THE FRONT CENTER HOOD SEAL .
- Refer to INSTALLING HOOD SEAL ON LEFT AND RIGHT SIDES .