Install brake booster

• Guide the brake booster (1)  into the firewall.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Replace nuts (1)  .

  Parts:  Nuts

• Install the nuts (1)  and tighten.

Courtesy of BMW OF NORTH AMERICA, INC.

• Install the retaining bolt (1)  through the brake pedal.

  Lightly grease the retaining bolt (1)  .

• Replace the retaining clip (2)  .

  Parts:  Retaining clip

• Mount the retaining clip (2)  on the retaining bolt.

Courtesy of BMW OF NORTH AMERICA, INC.

• Install air duct (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Install the check valve (1)  in the brake booster in the arrow direction.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING CONSOLE FOR WINDSHIELD WIPER SYSTEM COMPLETE WITH MOTOR .
• Refer to INSTALLING THE REAR COWL PANEL .
• Refer to INSTALLING THE GUTTER STRIP ON THE WINDSCREEN ON THE LEFT AND RIGHT .
• Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
• Refer to PREPARATIONS FOR INSTALLING THE TANDEM BRAKE MASTER CYLINDER .
• Refer to INSTALLING THE TANDEM BRAKE MASTER CYLINDER .
• Refer to INSTALLING THE EXPANSION TANK .
• Refer to INSTALLING THE SYSTEM BATTERY .
• Refer to INSTALLING INTAKE SILENCER HOUSING .
• Refer to INSTALLING THE INTAKE MANIFOLD FOR THE INTAKE FILTER HOUSING .
• Refer to INSTALLING THE STRUT BRACE .
• Refer to CONNECTING BATTERY GROUND LEAD .
• Refer to CONNECTING THE BRAKE FLUID BLEEDER UNIT (AFTER REPAIR) .
• Refer to FLUSHING AND BLEEDING THE REAR AXLE BRAKE CIRCUIT .
• Refer to FLUSHING AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT .
• Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID (AFTER REPAIR) .
• Refer to INSTALLING FRONT WINDSHIELD PANEL COVER .
• Refer to INSTALLING THE REAR HOOD SEAL .