Install the rear top cross connection
- Maneuver cross connection (3) from the rear in arrow direction.
- Tighten down screws (1) and (2) .
TIGHTENING TORQUE SPECIFICATION
| Top rear cross connection | ||
|---|---|---|
| Torx screw M8x30 | Tightening torque | 19 Nm |
| Hexagon screw M8x20 |
Tightening torque | 19 Nm |
Follow-up work
- Refer to INSTALLING UPPER CROSS CONNECTION .
- Refer to INSTALLING RIGHT INTAKE SILENCER HOUSING .
- Refer to TIGHTENING THE FRONT-END STRUT ON THE RIGHT .
- Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
- Refer to TIGHTENING THE LEFT FRONT-END STRUT .
- Refer to INSTALLING THE CENTER ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE FRONT HOOD SEAL .