Removing the Roof function center (FZD)

NOTE: RISK OF DAMAGE
Careless handling of tools and sharp-edged components.
Scratches, surface damage.

Protect working area.
Handle tools and components carefully.

NOTE: RISK OF DAMAGE
Electrostatic discharge.
Damage to or destruction of electrical components.

Leave the electrical components in their original packaging until they are being installed. Only use the original packaging for returning the product. Always package removed components straight away.
Read and comply with user information on using the associated special tool 12 7 060.
Only tap the housings of electrical components. Do not tap pins or multi-pin connectors directly.
Wear electrically conductive clothing and antistatic shoes (with ESD symbol).
For additional information see:
NOTES ON ESD (ELECTROSTATIC DISCHARGE) PROTECTION .

NOTE: TECHNICAL INFORMATION
With the optional equipment SA6UA, the camera for gesture control is integrated in the roof control module. Separate exchange of this camera in the event of a fault is not possible.

NOTE: TECHNICAL INFORMATION
Before replacing the control unit: If necessary, save the customer-specific vehicle settings.
Also determine and note the status of the function "rain closure" in the head unit menu.
After replacing the control unit, restore customer-specific settings.
The function "rain closure" may not be selected with US vehicles.

Unclip the cover (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Unclip the roof function center (FZD) (1) from the clamps (2).
Ease out the Roof function center (FZD) (1) from the guides (3).

Courtesy of BMW OF NORTH AMERICA, INC.
Unlock and disconnect plug connections (1).
Unclip the cable bracket from FZD (2) and remove FZD (2).

Courtesy of BMW OF NORTH AMERICA, INC.