Remounting the EMF actuator
- Release screws (3)
and remove the holder (4)
.
- Remove the EMF actuator (1)
in the direction of the arrow from the brake caliper.
- EMF actuator (1) Carefully fit controller drive until gearing engage and EMF actuator rests flush on brake caliper.
- If necessary, turn the EMF actuator slightly until the bore and the screw thread are aligned.
- Attach the holder (4) and position and tighten the bolts (3) .
TIGHTENING TORQUES SPECIFICATION
| EMF actuator to brake caliper | ||
|---|---|---|
| Replace screws. | tightening torque | 12 Nm |