Installing the trim strip
Precondition
Front door is open.
- Check clamp (1)
for damage.
Defective or missing clamps (1) need to be replaced.
- If necessary, release the nozzles (2)
from the clamps (1)
and mount them on the bodywork.
Faulty or missing nozzles (2) must be replaced.
- Correctly position the clamps (1)
on the trim strip (3)
.
- Carefully fit the trim strip (1) and thread the trim strip on to the side window.
- Carefully clip in the trim strip (1)
starting at the rear with the clips (2)
.
- Tighten down screw (1) .
TIGHTENING TORQUE SPECIFICATION
| Trim strip to frame | ||
|---|---|---|
| Screw | tightening torque | 2 Nm |