Install the seat belt finisher strip
- Feed the seat belt (2) into the seat belt finisher strip (1) .
- Clip the clip (3)
into the seat belt finisher strip (1)
.
- Position the seat belt finisher strip (2) on the rear side trim panel and clip it into the detent (3) .
- Replace the screw (1)
.
Part: Screw
- Tighten down screw (1) .
TIGHTENING TORQUE SPECIFICATION
| Seat belt finisher strip to angle bracket | ||
|---|---|---|
| Sheet metal screw 4.8x19 Replace screw. |
Tightening torque | 2.6 Nm |