Installing the instrument cluster (KOMBI)
WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.
- Connect and lock the connector (1) on the instrument cluster (KOMBI) (2).
- Guide in the instrument cluster (KOMBI) (2) and position it.
- Tighten down screws (1).TIGHTENING TORQUES SPECIFICATION
Instrument cluster (KOMBI) to support Screw tightening torque 1.8 Nm - Tighten down screw (1).TIGHTENING TORQUES SPECIFICATION
Instrument cluster (KOMBI) to support Screw tightening torque 1.8 Nm - Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Instrument cluster (KOMBI) to support | ||
| Screw | tightening torque | 1.8 Nm |
Follow-up work
- Refer to FITTING STEERING COLUMN SHROUD UPPER SECTION .
- Refer to INSTALLING THE DECORATIVE STRIP ON THE DASHBOARD ON THE LEFT .
- Refer to INSTALLING THE SIDE PANEL ON LEFT DASHBOARD .
- Refer to INSTALLING THE CENTRAL INFORMATION DISPLAY (CID) .
- Refer to INSTALLING THE DECORATIVE STRIP ON THE RIGHT DASHBOARD .
- Refer to INSTALLING THE SIDE PANEL ON DASHBOARD ON THE RIGHT .
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS . .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .