Installing the left and right headlight
WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Insert the headlight (3) from the front and clip it in with the detent (2).
- Tighten the screws (1).TIGHTENING TORQUES SPECIFICATION
Front light combination, top Oval-head screw Tightening torque 8 Nm - Secure connector holder (1) to the headlight.
- Tighten down screw (2).TIGHTENING TORQUES SPECIFICATION
Front light combination, bottom Oval-head screw Tightening torque 5 Nm - Connect connectors (1) and lock.
- Remove adhesive tape in the marked area.
Follow-up work
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to PARTIALLY INSTALLING THE TEMPERATURE SENSOR .
- Refer to PARTIALLY INSTALLING THE FRONT LEFT AND RIGHT WHEEL ARCH TRIM PANELS .
- Refer to INSTALLING THE CENTER ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE FRONT HOOD SEAL .
- Refer to PROCESSING THE LED HEADLIGHT SERVICE TEST MODULE .
- Refer to ADJUSTING HEADLIGHTS .