Installing the storage net
WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.
- Measure the reference dimension on the template (1) and cut it out as shown.
- Place the template (1) as shown on the luggage compartment wheel arch trim panel (2) and fasten it with adhesive tape.
- Drill holes all the way through at the marks using the Ø 6.5 mm drill bit from the special tools 5 A63 022 .
- Remove the template (1).
- Measure the reference dimension on the template (1) and cut it out as shown.
- Fix the template (1) as shown with a standard pencil (3) on the existing bore.
- Drill through the luggage compartment wheel arch trim panel (2) on the mark with the drill ø 10 mm from the special tool 5 A63 022 .
- Remove the template (1).
- Measure the reference dimension on the template (1) and cut it out as shown.
- Place the template (1) as shown on the luggage compartment wheel arch trim panel (2) and fasten it with adhesive tape.
- Drill holes all the way through at the marks using the ø 10 mm drill bit from the special tools 5 A63 022 .
- Remove the template (1).NOTE: Schematic diagram is for example purposes. Some parts may differ in certain details.
- Insert the holder (1) into the bores and lock in place correctly.NOTE: Schematic diagram is for example purposes. Some parts may differ in certain details.
- Screw in the holder (1) in the bores 0 6.5 mm.NOTE: Schematic diagram is for example purposes. Some parts may differ in certain details.
- Insert the storage net (1) at the top as shown and snap it in correctly on the holders below.
Follow-up work
- Refer to INSTALLING THE 12 V SOCKET IN THE LUGGAGE COMPARTMENT .
- Refer to INSTALLING LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON RIGHT .
- Refer to INSTALLING THE TOP LUGGAGE COMPARTMENT TRIM PANEL .
- Refer to INSTALLING LOADING EDGE TRIM .
- Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .