Installing the headlining (with sliding/tilting sunroof) (lowered)

Precondition 

The front seats have been fully adjusted towards the bottom.

The front seat backrests have been fully adjusted towards the rear.

The rear seat backrest is folded down toward the front.

• Install the end support of the sun visors (1) in the headlining and mount it with clamps (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Check the clips (1) on the headlining for damage.

  Defective or missing clips (1) must be replaced.

• Check the clamps (2) along the dotted line for damage.

  Defective or missing clamps (2) need to be replaced.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert the headlining (1) with the help of an auxiliary person onto the respective edge protection.
• Clip in headlining (1) on the clips (2).
• Clip the headlining (1) in the area of the dotted line at the slide/tilt sunroof unit and the clamps (3).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Clip headlining to the clips (2).
• Tighten down screw (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Headlining on frame
  Oval-head screw	tightening torque	1.5 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Secure expanding rivet (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to TRIMMING OF THE 3RD INSTALLING THE BRAKE LIGHT .
• Refer to INSTALLING THE LEFT AND RIGHT B-PILLAR TRIM PANEL .
• Refer to INSTALLING LEFT AND RIGHT REAR SIDE TRIM PANEL .
• Refer to INSTALLING THE INNER DOOR SILL COVER STRIP ON THE LEFT AND RIGHT .
• Refer to INSTALLING THE LEFT AND RIGHT C-PILLAR TRIM PANEL .
• Refer to INSTALLING THE LEFT AND RIGHT BACKREST SIDE SECTION .
• Refer to INSTALLING THE REAR SEAT .
• Refer to INSTALLING ROOF FUNCTION CENTER (FZD) .
• Refer to INSTALLING THE LEFT AND RIGHT SUN VISORS AND COUNTER SUPPORT .
• Refer to INSTALLING A-PILLAR TRIM PANEL, LEFT AND RIGHT .