Install A-pillar trim panel
WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Pyrotechnic components.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.
- Replace any damaged part or ones that have been dropped.
- For additional information see: 72 00 SAFETY REGULATIONS ON HANDLING COMPONENTS WITH GAS GENERATORS .
NOTE:
RISK OF DAMAGE
Damage to the head airbag.
Improper use of a tool when removing the trim panel may damage the head airbag.
Damage to the head airbag.
Improper use of a tool when removing the trim panel may damage the head airbag.
- Do not use sharp-edged tools when removing the trim panel.
Check
- Check the snap-in lug (1) of the cover (2) for damage.
Result
» Snap-in lug is damaged.
Measure
- Replace cover.
Check
- Check the clips (1) for damage and replace if necessary.
- Check guides (3) for damage.
Result
» The guide is damaged.
Measure
- Replace the A-pillar trim panel.
- Insert the A-pillar trim panel (3) downwards and clip in with the clips (4).
- Tighten down screw (2).TIGHTENING TORQUE SPECIFICATIONS
A-pillar trim panel to body Sheet metal screw 4.8x38 Tightening torque 2.6 Nm - Clip in the cover (1).