Remove the module bracket from the front door

WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Working on 12 V electrical system.
Risk of short circuits! Risk of fire!

Make sure that there is no charger connected to the jump start terminal in the engine compartment.
Detach battery ground lead from battery.
For auxiliary batteries: Detach battery minus cables from all auxiliary batteries.

Preliminary work

Refer to DEACTIVATING THE 48 V ELECTRICAL SYSTEM .
Refer to DISCONNECTING ALL BATTERY GROUND LEADS . .
Refer to REMOVING FRONT DOOR TRIM PANEL .

Unlock and disconnect plug connections (1).
Unclip wiring harness (2) on the module bracket on the front door.
Release the rubber grommet of the Bowden cable for the inner door opener (3).

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Open bayonet closures (1) by twisting them and remove the module bracket on the front door (2).
In the process, guide out the

Bowden cable for the inner door opener (3) from the module bracket on the front door (2).

Courtesy of BMW OF NORTH AMERICA, INC.