Adjusting rear lid lock

NOTE: TECHNICAL INFORMATION
Notes for the gap dimensions of the body form the basis of this REP and it is mandatory to observe them.
For additional information see: 41 00... GAP DIMENSIONS FOR BODY .
.

Lever out the covers (1) on the marked recesses (arrows) with a screwdriver and remove them.
Loosen screws (2) until the tailgate lock can be shifted.
Adjusting tailgate lock.

Courtesy of BMW OF NORTH AMERICA, INC.

Check
Check the gap dimensions between the trunk lid and the bumper cover.

Courtesy of BMW OF NORTH AMERICA, INC.

Result

» Gap dimensions do not correspond to the specifications.

Measure
Adjust tailgate latch.

Tighten down screws (1).

TIGHTENING TORQUE SPECIFICATIONS

Tailgate lock to body
M8x20 screw	Tightening torque	19 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Clip in the covers (2).
Adjust stop pad (1).

Courtesy of BMW OF NORTH AMERICA, INC.