Installing the module bracket on the front door

• Check seal (1) of the module bracket (2) for damage.

  If the seal (1) is damaged, the module carrier (2) must be replaced.

• Open all the snap fasteners (3).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in the module bracket (2) and close the snap fasteners (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten the screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Module bracket to door
  screw	Tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Secure the wiring harness (2) to all cable clips.
• Connect connector (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

  Disconnecting all battery ground leads 

• See additional information.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Shift the power window upwards until the side window glass correctly engages in both holders.
• Remove adhesive tape.

Follow-up work 

• Refer to INSTALLING FRONT DOOR TRIM PANEL .
• Refer to ATTACHING THE COVER TO THE DOOR HANDLE .
• Refer to INSTALLING THE WEATHER STRIP ON THE FRONT DOOR .
• Refer to FITTING VEHICLE EXTERIOR MIRROR .
• Refer to INSTALLING THE MIRROR TRIANGLE COVER .
• Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .