Install the headlining on the left or right (with SA403 glass roof)
NOTE:
RISK OF DAMAGE
Electrostatic discharge.
Damage to or destruction of electrical components.
Electrostatic discharge.
Damage to or destruction of electrical components.
- Leave the electrical components in their original packaging until they are being installed. Only use the original packaging for returning the product. Always package removed components straight away.
- Read and comply with user information on using the associated special tool 12 7 060.
- Only tap the housings of electrical components. Do not tap pins or multi-pin connectors directly.
- Wear electrically conductive clothing and antistatic shoes (with ESD symbol).
- For additional information see: 61 35... NOTES ON ESD (ELECTROSTATIC DISCHARGE) PROTECTION .
NOTE:
RISK OF DAMAGE
Careless handling of tools and sharp-edged components. Scratches, surface damage.
Careless handling of tools and sharp-edged components. Scratches, surface damage.
- Protect working area.
- Handle tools and components carefully.
Preliminary work
- Refer to REMOVING A-PILLAR TRIM PANEL .
- Refer to REMOVING THE COUNTER SUPPORT FOR THE SUN VISOR .
- Refer to REMOVING SUN VISOR .
- Refer to REMOVING THE VANITY MIRROR LIGHT AT THE FRONT LEFT OR RIGHT .
- Refer to REMOVING RIGHT HANDS-FREE MICROPHONE .
- Refer to REMOVING THE ROOF FUNCTION CENTER (FZD) .
- Refer to REMOVING THE COVERS FOR THE INTERIOR REARVIEW MIRROR .
- Refer to REMOVING THE INTERIOR REARVIEW MIRROR .
- Refer to REMOVING REAR INTERIOR ROOF LIGHT .
- Refer to REMOVING THE B-PILLAR TRIM PANEL UPWARDS .
- Refer to REMOVING C-PILLAR TRIM PANEL .
- Refer to INSTALLING THE HOLDER ON LEFT OR RIGHT .
Precondition
Glass roof is open.
- Feed in the headlining on the relative edge protection.
- Secure the frame (1) to the roof using the clips (2).
- If necessary, clip in the cable clip into the frame (1).
- Clip in the headlining using the clips (1).
- Secure the frame (1) to the roof using the clips (2).
- Clip in trim (1) using clips (2).
- Tighten down screw (1).TIGHTENING TORQUE SPECIFICATIONS
Headlining 2.5 Nm - Tighten the screws (1).TIGHTENING TORQUE SPECIFICATIONS
Headlining to panorama glass roof 1.2 Nm
Follow-up work
- Refer to INSTALLING THE HOLDER ON LEFT OR RIGHT .
- Refer to INSTALLING C-PILLAR TRIM PANEL .
- Refer to INSTALLING THE UPPER B-PILLAR TRIM PANEL .
- Refer to INSTALLING REAR INTERIOR ROOF LIGHT .
- Refer to INSTALLING THE INTERIOR REARVIEW MIRROR .
- Refer to INSTALLING THE COVERS FOR THE INTERIOR REARVIEW MIRROR .
- Refer to INSTALLING ROOF FUNCTION CENTER (FZD) .
- Refer to INSTALLING THE SUN VISOR .
- Refer to INSTALLING THE COUNTER SUPPORT FOR THE SUN VISOR .
- Refer to INSTALLING THE VANITY MIRROR LIGHT AT THE FRONT LEFT OR RIGHT .
- Refer to INSTALLING THE RIGHT HANDS-FREE MICROPHONE .
- Refer to INSTALLING A-PILLAR TRIM PANEL .