Installing transmission cross member
- Install the transmission cross member (3).
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Transmission cross member to rubber mounts | ||
| M12 | tightening torque | 68 Nm |
- Tighten down screws (2).
TIGHTENING TORQUES SPECIFICATION
| Transmission cross member to body | ||
| M8 | tightening torque | 19 Nm |
- Release the luggage strap (1) from the transmission.
- Remove the special tools 0 495 498 (23 4 050) and 2219 012.
Follow-up work
- Refer to INSTALLING REAR UNDERBODY PROTECTION .