Install the intake pipe
- Replace the O-rings of the intake pipe (2)
.
Parts: O-rings
- Completely feed in the intake pipe (2) and position correctly.
- Close the holder (arrow).
- Tighten down screw (1) .
TIGHTENING TORQUES SPECIFICATION
| Refrigerant line to air conditioning condenser/connecting piece | ||
|---|---|---|
| M8 | tightening torque | 19 Nm |
- Place the intake pipe (2) on the air conditioning compressor (3) .
- Tighten the screw (1) from the side of the wheel well on the intake pipe (2) .
TIGHTENING TORQUES SPECIFICATION
| Refrigerant line on air conditioning compressor | ||
|---|---|---|
| M8 | tightening torque | 19 Nm |
Follow-up work
- Refer to ATTACHING THE FRONT LEFT WHEEL .
- Refer to INSTALLING FAN COWL WITH ELECTRIC MOTOR .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING RIGHT INTAKE SILENCER HOUSING .
- Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
- Refer to INSTALLING FRONT CROSS CONNECTION .
- Refer to TIGHTENING THE LEFT FRONT-END STRUT .
- Refer to TIGHTENING THE FRONT-END STRUT ON THE RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .
- Refer to INSTALLING THE COVER PANEL OF THE MASTER DME CONTROL UNIT .
- Refer to INSTALLING THE COVER PANEL OF THE SLAVE DME CONTROL UNIT .
- Refer to EVACUATING AND CHARGING CONDITIONING .