Install the module bracket on the rear door

• Check seal (1) of the module bracket (2) for damage.

  If the seal (1) is damaged, the module carrier (2) must be replaced.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in module bracket completely with the power window and close the snap fasteners (2).
• Attach wiring harness (1) and connect the plug connections.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten the screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Module bracket to door
  screw	Tightening torque	8 Nm

• Shift the power window upwards until the side window glass correctly engages in the holder.
• Remove adhesive tape.

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING REAR DOOR TRIM PANEL .
• Refer to ATTACHING THE COVER TO THE DOOR HANDLE .
• Refer to INSTALLING WINDOW CHANNEL STRIP ON THE REAR DOOR .