Removing the left Lambda oxygen sensor
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
Preliminary work
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING LEFT INTAKE SILENCER HOUSING .
- Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
- Refer to REMOVING THE COVER OF THE REAR RIGHT ENGINE COMPARTMENT .
- Refer to REMOVING THE COWL COVER .
- Refer to REMOVING TRAILING LINK AT SPRING BOLT .
- Refer to REMOVING THE SEAL FOR THE HOOD REAR .
- Refer to REMOVING THE COWL UPPER PART IN THE CENTER .
- Refer to REMOVING LEFT THROTTLE VALVE ASSEMBLY .
- Refer to REMOVING TOP CLEAN AIR PIPE AT LEFT .
- Refer to REMOVING CHARGE AIR PIPE ON LEFT .
- Unlock plug connection (1) and disconnect.
- Release the plug connection (1)
from the carrier plate.
- Open cable clips (1)
.
- Detach the cable (1)
from the clamp (2)
.
- Prepare tools:
Connect the swiveling extension (1) and the special tool 0 491 074 (11 7 020) .
- Release the Lambda oxygen sensor (1) with swiveling extension (2) and the special tool 0 491 074 (11 7 020) .
- Remove the Lambda oxygen sensor (1) .