Install the electric changeover valve for the vacuum control of the engine mounts

• Make sure the green O-ring (1)  is installed correctly.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Make sure the green O-ring (3)  between the red vacuum hose (2)  and the electric changeover valve is installed correctly.

  The vacuum hose (1)  is black.

  The vacuum hose (2)  is red.

• Connect the vacuum hoses (1)  and (2)  to the electric changeover valve.

Courtesy of BMW OF NORTH AMERICA, INC.

• Connect the electric changeover valve (1)  to the holder.
• Make sure that the electric changeover valve (1)  engages correctly in the highlighted area.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect plug (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE THROTTLE BODY (CHARGE AIR LINE REMOVED) .
• Refer to INSTALLING THE FRONT HOLDER FOR THE INTAKE PLENUM .
• Refer to INSTALLING THE ACOUSTIC COVER FOR THE ENGINE AT THE FRONT .
• Refer to INSTALLING CHARGE AIR LINE .
• Refer to INSTALLING CLEAN AIR PIPE .
• Refer to INSTALLING RESONATOR .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to ACTIVATING HIGH-VOLTAGE SYSTEM .
• Refer to INSTALLING FLAP IN RIGHT LUGGAGE COMPARTMENT TRIM PANEL .