Install front engine encapsulation

• Check the engine encapsulation (1)  for damage and replace if necessary.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Carefully pull the engine wiring harness (1)  forward.
• Insert the engine encapsulation (2)  from the top.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect the connector (3)  with the heat management module.
• Connect the connector (2)  to the heating element.
• Connect the connector (1)  to the turbocharger.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Secure the engine encapsulation with the expanding rivet (2)  .
• Connect connector (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Clip in the engine wiring harness (1)  in the highlighted areas.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Replace the O-ring for the oil feed line.

  Parts:  O-ring

• Position oil feed line (2)  .
• Tighten down screw (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING AUXILIARY COOLANT PUMP FOR THE TURBOCHARGER .
• Refer to INSTALLING THE ACOUSTIC COVER FOR THE ENGINE AT THE FRONT .
• Refer to CONNECTING THE COOLANT LINE OF HIGH-TEMPERATURE COOLANT CIRCUIT .
• Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
• Refer to INSTALLING CHARGE AIR LINE .
• Refer to INSTALLING CLEAN AIR PIPE .
• Refer to INSTALLING RESONATOR .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to VENTING THE HIGH-TEMPERATURE COOLANT SYSTEM .
• Refer to INSTALLING FRONT STIFFENING PLATE .
• Refer to INSTALLING THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .