Installing the right-hand charge air cooler
- Feed in charge air cooler (1) to the guide (2) and into the throttle body.
- Lock the lock (3) audibly.
- Tighten down screw (4) .
TIGHTENING TORQUE SPECIFICATIONS
| Charge air cooler to holder | ||
|---|---|---|
| M6x35 | tightening torque | 8 Nm |
- Connect coolant line (1) to the charge air cooler and lock it audibly.
- Connect coolant line (2) to the charge air cooler and lock it audibly.
- Secure the holder for the coolant hoses (3) on the charge air cooler.
- Secure the coolant line (4)
on the charge air cooler.
- Secure the plug connection (1) on the charge air cooler.
- Secure the tank vent valve (2) on the charge air cooler.
- Connect connector (3) to the pressure sensor on the charge air cooler and lock audibly.
Follow-up work
- Refer to INSTALLING THE RIGHT UNFILTERED-AIR DUCT .
- Refer to CONNECTING THE RIGHT CHARGE AIR LINE TO THE EXHAUST TURBOCHARGER .
- Refer to INSTALLING INTAKE FILTER HOUSING .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to CONNECTING THE COOLANT HOSE TO THE AUXILIARY COOLANT PUMP .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT THRUST FIELD .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING FRONT CROSS CONNECTION (FRONT-END STRUT REMOVED) .
- Refer to INSTALLING BOTH FRONT-END STRUTS .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT CENTER .
- Refer to FILLING THE LOW-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
- Refer to VENTING THE LOW-TEMPERATURE COOLING SYSTEM .