Installing fan cowl

Precondition 

Ignition is switched off.

• Feed in and install the fan cowl (1)  in the direction of the arrow.
• Fasten the coolant hose to the fan cowl.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect the connector (1)  to the fan cowl and lock audibly.
• Connect the connector (2)  to the coolant temperature sensor and lock it audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Fasten the cable with the clamp (1)  at left on the fan cowl.

  Courtesy of BMW OF NORTH AMERICA, INC.

• If fitted: 

  Fasten the coolant line (1)  at left on the fan cowl with the clamp (2)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Fasten the coolant hoses with the clamps (1)  to the fan cowls.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
• Refer to INSTALLING FRONT CROSS CONNECTION (FRONT-END STRUT REMOVED) .
• Refer to INSTALLING BOTH FRONT-END STRUTS .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT CENTER .