Removing The Rear Left Side Panel

NOTE: TECHNICAL INFORMATION
For additional information see: 41 00... Releasing bonded connections

NOTE: TECHNICAL INFORMATION
For additional information see: 41 00... Loosening bonded folded joints

Courtesy of BMW OF NORTH AMERICA, INC.

Mark severance cuts in accordance with specified dimensions and cut. Thereby disconnect only the outer panel.
Dimension = 63 mm from the center of the hole with Ø 20 mm.
Dimension = 110 mm from the roof outer skin corner.
Release welded connections in areas (1).
Release the spot-welded adhesive joints in area (2).
Release folded bonded joints in area (3).
Release the side panel from the cavity sealings (4).
NOTE: TECHNICAL INFORMATION
For additional information see: 41 00... Determination of separating cut using a template
Determine position of the severance cut in addition to the dimensions with the aid of a template (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Open welded connections in areas (1) and (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Open welded connections in areas (1) and (2). Remove side wall.

Courtesy of BMW OF NORTH AMERICA, INC.
Open welded connections in area (1).
Release bonded joint (2).
Remove lock striker reinforcement.

Courtesy of BMW OF NORTH AMERICA, INC.