Removing the high-pressure nozzle of the headlight cleaning system
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Lever out the cover panel (1) with the special tool 0 493 687 (00 9 340) .
- Slowly pull out high-pressure nozzle of headlight cleaning system from cover (1).
- Unclip the cover (2) from the guide (1) at the side in the direction of the arrow and remove to the front.
- Allow the high-pressure nozzle (3) of headlamp washer system to slide back slowly.
- Unlock and disconnect high pressure line (1).
- Unlock the detents (2).
- Remove the high-pressure nozzle (3) towards rear.