Remount the holder of the hydraulic unit and remount the brake lines
Remount hydraulic unit holder
- Release screws (1) and remove the holder (2).
- Install holder (2).
- Insert screws (1) and tighten them.
TIGHTENING TORQUE SPECIFICATIONS
| Hydraulic control unit to holder | ||
|---|---|---|
| M6 Replace screws. |
Tightening torque | 8 Nm |
Remount brake lines at the hydraulic unit
- Release all brake lines (1) and completely remove with the holders.
- Fit all brake lines (1) completely with the holders.
- Tighten all brake lines (1).
TIGHTENING TORQUE SPECIFICATIONS
| Brake pipe screw connection/Union screws | ||
|---|---|---|
| tightening torque | 17 Nm | |