Install the oil vacuum pump
- Check guide sleeves (1) for damage and replace if necessary.
Parts: Guide sleeves
- Make sure the sealing ring (1) is installed correctly.
The sealing ring (1) must not be damaged or missing.
- Insert oil vacuum pump (1) into the drive chain (2).
- Position oil vacuum pump (2) correctly on the guide sleeves.
- Tighten the screws (1).TIGHTENING TORQUES SPECIFICATION
Oil vacuum pump to crankcase M8
Replace screw.1. Joining torque 15 Nm 2. Angle of rotation 45°
Follow-up work
- Refer to REFITTING ENGINE OIL PAN .
- Refer to INSTALLING THE STARTER MOTOR (ACOUSTIC COVER REMOVED) .
- Refer to TIGHTENING THE OIL DRAIN PLUG .
- Refer to INSTALLING THE ACOUSTIC COVER FOR THE OIL SUMP .
- Refer to INSTALLING FRONT AXLE COMPLETELY .
- Refer to TIGHTENING THE SCREWS ON THE LEFT AND RIGHT FRONT AXLE SUPPORT .
- Refer to SECURING THE SPRING STRUT ON THE WISHBONE ON THE BOTTOM LEFT AND RIGHT .
- Refer to SECURING THE TOP WISHBONE ON THE SWIVEL BEARING .
- Refer to REMOVING THE MOBILE LIFTING TABLE .
- Refer to IF INSTALLED: CONNECT THE CONNECTOR OF THE ACTIVE STABILIZER .
- Refer to SECURING BRAKE HOSE, FRONT RIGHT AND LEFT .
- Refer to SECURING THE ANTI-ROLL BAR LINK ON THE LEFT AND RIGHT TO THE ANTI-ROLL BAR .
- Refer to IF INSTALLED: INSTALL THE SILENCER OF THE STATIONARY HEATING (ADDITIONAL WORK FRU NO.: 31 11 905) .
- Refer to SECURING THE WIRING HARNESS FOR THE EPS ON THE FRONT AXLE SUPPORT .
- Refer to IF INSTALLED: CONNECT THE VACUUM HOSE OF THE ENGINE MOUNT ON THE FRONT AXLE SUPPORT .
- Refer to TIGHTENING THE OIL FILTER CAP .
- Refer to LOWERING THE ENGINE AND DETACHING THE ENGINE BRIDGE .
- Refer to INSTALLING THE ENGINE SUPPORT ARMS ON THE ENGINE MOUNTS ON THE LEFT AND THE RIGHT .
- Refer to ATTACHING THE UNIVERSAL JOINT TO STEERING GEAR .
- Refer to INSTALLING THE REINFORCEMENT STRUT ON THE ENGINE MOUNT ON THE LEFT AND RIGHT .
- Refer to INSTALLING REAR UNDERBODY PROTECTION .
- Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT THRUST FIELD .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
- Refer to INSTALLING THE COVER OF THE STEERING ASSEMBLY ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE REAR SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE WHEEL ARCH COVER ON THE FRONT LEFT AND BOTTOM RIGHT .
- Refer to INSTALLING LEFT AND RIGHT BRAKE VENTILATION DUCT .
- Refer to INSTALLING THE FRONT LEFT AND RIGHT WHEELS .
- Refer to TOPPING UP THE MOTOR OIL .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to INSTALLING THE COVER ON THE LEFT AND RIGHT IN THE ENGINE COMPARTMENT AT THE TOP .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to TAKING HOOD OUT OF THE SERVICE POSITION .
- Refer to CONNECTING NEGATIVE BATTERY CABLE .
- Refer to RESETTING THE TIRE PRESSURE MONITOR .
- Refer to CHECKING ENGINE OIL LEVEL .