Installing the instrument cluster (KOMBI)
- Connect and lock the connector (1)
on the instrument cluster (KOMBI) (2)
.
- Guide in the instrument cluster (KOMBI) (2) and position it.
- Tighten down screws (1) .
TIGHTENING TORQUE SPECIFICATION
| Instrument cluster (KOMBI) to support | ||
| Screw | tightening torque | 1.8 Nm |
- Tighten down screw (1) .
TIGHTENING TORQUE SPECIFICATION
| Instrument cluster (KOMBI) to support | ||
| Screw | tightening torque | 1.8 Nm |
- Tighten down screw (1) .
TIGHTENING TORQUE SPECIFICATION
| Instrument cluster (KOMBI) to support | ||
| Screw | tightening torque | 1.8 Nm |
Follow-up work
- Refer to FITTING STEERING COLUMN SHROUD UPPER SECTION .
- Refer to INSTALLING THE DECORATIVE STRIP ON THE DASHBOARD ON THE LEFT .
- Refer to INSTALLING THE SIDE PANEL ON LEFT DASHBOARD .
- Refer to INSTALLING THE CENTRAL INFORMATION DISPLAY (CID) .
- Refer to INSTALLING THE DECORATIVE STRIP ON THE RIGHT DASHBOARD .
- Refer to INSTALLING THE SIDE PANEL ON DASHBOARD ON THE RIGHT .
- Refer to CONNECTING NEGATIVE BATTERY CABLE OF THE SYSTEM BATTERY .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .