Installing the bumper cover trim

Check 

• Check the detents (1)  on the bumper cover (2)  for damage.

Courtesy of BMW OF NORTH AMERICA, INC.

Result 

» The detents are damaged.

Measure 

• Replace the bumper cover.

• Position the trim (1)  of the bumper cover and clip it into the detents (2)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING FOG LIGHT SUPPORT .
• Refer to PARTIALLY INSTALLING THE BUMPER BRACKET .
• Refer to INSTALL BUMPER COVER, FRONT .
• Refer to PARTIALLY INSTALLING THE TEMPERATURE SENSOR .
• Refer to PARTIALLY INSTALLING THE FRONT LEFT AND RIGHT WHEEL ARCH TRIM PANELS .
• Refer to INSTALL CENTER RADIATOR GRILLE .
• Refer to INSTALLING THE COVER FOR CENTER ENGINE COMPARTMENT .
• Refer to INSTALLING THE FRONT HOOD SEAL .