Installing the air duct on the radiator
NOTE:
The operations shown only for one side must be carried out on both sides.
- Feed in and install the air duct (2) .
- Fasten the expanding rivet (1)
.
- Fasten expanding rivet (1) .
Follow-up work
- Refer to INSTALLING INTAKE PORT .
- Refer to INSTALLING INTAKE FILTER HOUSING .
- Refer to INSTALLING LEFT AND RIGHT BRAKE VENTILATION DUCT .
- Refer to INSTALL REINFORCEMENT STRUT .
- Refer to INSTALLING THE LEFT AND RIGHT FANFARE HORN .
- Refer to INSTALLING THE PEDESTRIAN PROTECTION SENSOR .
- Refer to INSTALLING THE BOTTOM AUTOMATIC AIR FLAP CONTROL .
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to IF INSTALLED: INSTALLING THE FRONT RADAR SENSOR (FRS) WITH THE BRACKET .
- Refer to INSERT TOP AUTOMATIC AIR FLAP CONTROL .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to PARTIALLY INSTALLING THE TEMPERATURE SENSOR .
- Refer to PARTIALLY INSTALLING THE FRONT LEFT AND RIGHT WHEEL ARCH TRIM PANELS .
- Refer to INSTALLING COVERS AT FRONT BOTTOM ON LEFT AN RIGHT SIDES .
- Refer to INSTALL FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING CENTER RADIATOR GRILLE .
- Refer to INSTALLING THE COVER FOR CENTER ENGINE COMPARTMENT .
- Refer to INSTALL THE FRONT HOOD SEAL .
- Refer to ADJUSTING HEADLIGHTS .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .