Body Gap Dimensions Rep-Rep-RAI0141-4106200 - V.2

The dimensions specified in this service information are applicable at an object temperature of 20°C. The aim of adjustment is to achieve a uniform gap .

Symmetry of the gaps between left and right sides of the vehicle has top priority .

For door gaps, the maximum deviation between the front and rear door gaps must be 1.0 mm .

No gap dimensions are specified for components/gaps which cannot be adjusted .

Dimensions in mm

Fig 1: Hood, Headlamp, Fender And Trim Panel Body Gap Dimensions And Measurement Points

Courtesy of BMW OF NORTH AMERICA, INC.

No range of adjustment between side panel and front bumper cover.

Fig 2: Sunroof And Roof Body Gap Dimensions And Measurement Points

Courtesy of BMW OF NORTH AMERICA, INC.

Slide/tilt sunroof lid
Roof

NOTE: Measure front and rear height adjustment over the entire cover width.

Height over the entire cover width must lie within tolerance.

The lateral distance between the slide/tilt sunroof lid and the roof must be approximately the same on the left and right.

Fig 3: Fender, Front Door And Trim Panel Body Gap Dimensions And Measurement Points

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 4: Front Door, Rear Door, Quarter Panel And Trim Panel Body Gap Dimensions And Measurement Points

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 5: Front Door Glass, Rear Door Glass And Quarter Glass Body Gap Dimensions And Measurement Points

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 6: Roof, Tailgate, Roof Frame Cover And Side Window Trim Body Gap Dimensions And Measurement Points

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 7: Tailgate, Quarter Panel And Rear Bumper Body Gap Dimensions And Measurement Points

Courtesy of BMW OF NORTH AMERICA, INC.

No range of adjustment between rear quarter panel and rear bumper panel.