Remove the front sill trim
NOTE:
RISK OF DAMAGE
Bending of plastic components.
Application of too much force can lead to bending of plastic components.
Bending of plastic components.
Application of too much force can lead to bending of plastic components.
- Place special tool directly beside the mounting clip.
- Continue unclipping the part without using the tool if possible.
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Release the front sill trim (1) with the special tool 0 496 570 (00 9 326) at the clips (2) .
- Remove the front sill trim (1)
.