Replacing rear left or right ride height sensor (X6 M)
IMPORTANT:
Observe SAFETY INSTRUCTIONS
for raising the vehicle!
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION)
!
Unfasten plug connection (1) and disconnect.
Release nut (2) and disconnect jointed rod.
Tightening torque 37 14 4AZ .
Installation note:
Sensor lever (3) must point from ride height sensor to respective rear wheel.
Replace self-locking nut.
Release screws (1) and remove ride height sensor (3).
Tightening torque 37 14 2AZ .
Installation note:
Only on F15/F16/F85/F86 vehicles:
Holder (1) of the ride height sensor must be mounted on the axle support in such a way that the area marked in the image (1) and (2) has the maximum size!
Non-compliance can lead to fault message and vehicle inclination.
Replacement:
Release screws (1). Detach holder (2) from ride height sensor.
Tightening torque 37 14 3AZ .
After installation:
- Carry out RIDE HEIGHT ADJUSTMENT .
- Check HEADLIGHT SETTING , correct if necessary