Removing and installing/replacing airbag module for passenger knee protection (X6 M)

Incorrect handling can activate airbag and cause injury.

Attention! 

Operations on pyrotechnical devices may only be carried out by authorized experts.

Improper, unauthorized operations may result in serious dangers.

Unauthorized persons are strictly prohibited from performing any operations on this system  .

Necessary preliminary tasks: 

• Disconnect NEGATIVE BATTERY LEAD .
• Remove LOWERING INSTRUMENT PANEL TRIM .

Removal: 

Release screws (1).

Unclip airbag module (2) and unlock and disconnect PLUG CONNECTION LOCATED BEHIND .

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Connect the connector to the airbag module (2).

Replace screws (1).

Parts:  Bolts

Clip in airbag module (2) and tighten the screws (1).

Tightening torque 72 12 03 AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Required reworking: 

• Install BOTTOM INSTRUMENT PANEL TRIM .
• Connect BATTERY EARTH LEAD .