Removing and installing/replacing the radiator for charge air (S63, B44 T 2) (X6 M)

Recycling: 

Coolant emerges when coolant lines are detached. Catch and dispose of escaping coolant in a suitable container.

Observe country-specific waste disposal regulations.

Necessary preliminary work: 

• Remove INTAKE PORT .
• Remove front UNDERBODY PROTECTION .

Removal: 

Unlock and detach coolant lines (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Slightly lower the radiator including transmission oil cooler.

Courtesy of BMW OF NORTH AMERICA, INC.

Release lock (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Push out the transmission oil cooler (1) from the bracket in the direction of the arrow and place to one side.

Do not  loosen transmission oil lines.

Remove the radiator including bracket (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Loosen the screws (1) and remove the radiator from the bracket.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Install the radiator in the bracket and tighten the screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Push the transmission oil cooler (1) into the bracket (2) in the direction of the arrow and install it.

Courtesy of BMW OF NORTH AMERICA, INC.

Lock the lock (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Install the radiator including transmission oil cooler and secure using screws.

Tighten down screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Connect and lock coolant lines (1).

The coolant lines (1) must audibly engage.

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Install the INTAKE PORT .
• Install front UNDERBODY PROTECTION .
• Top up COOLANT .