Replacing pulse sensor on left intake camshaft (S63 B44 T 2) (X6 M)
Repair applies to the (cylinder bank 5 to 8)
Necessary preliminary tasks:
- Read out fault memory of the DME control unit, work through test plans if necessary.
- Switch off ignition.
- Remove ACOUSTIC COVER .
Removal:
Unlock connector (1) and pull off.
Release screw (2).
Remove pulse generator (3).
Preparation for installation:
Part: Replace sealing ring and coat with lubricant.
Installation:
Remove pulse generator (3).
Tighten screw (2).
Tightening torque 13 62 3AZ .
Connect and lock the connector (1).
Connector (1) must engage audibly.
Required follow-up work:
- Install the ACOUSTIC COVER .