Remove the coolant expansion tank for the low-temperature coolant circuit
Preliminary work
- Remove the front UNDERBODY PROTECTION .
- Remove bottom left front wheel arch COVER .
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
CAUTION:
Materials harmful to health.
Contact with fluids harmful to health!
Contact with fluids harmful to health!
- Note and follow safety instructions on containers.
- Conduct all work in appropriate personal protective equipment only.
NOTE:
TECHNICAL INFORMATION
Immobilization period-long fill of coolant!
Do not reuse used coolant.
When replacing and removing components which rely on the corrosion protection effect of the coolant, it is essential to change the coolant. The cooling system must therefore be emptied and refilled.
In the case of other removal work involving the draining of part quantities of coolant, the coolant level must be topped up with new coolant.
Immobilization period-long fill of coolant!
Do not reuse used coolant.
When replacing and removing components which rely on the corrosion protection effect of the coolant, it is essential to change the coolant. The cooling system must therefore be emptied and refilled.
In the case of other removal work involving the draining of part quantities of coolant, the coolant level must be topped up with new coolant.
NOTE:
TECHNICAL INFORMATION
Use commercially available pinch-off tools to pinch off the coolant hoses.
Use commercially available pinch-off tools to pinch off the coolant hoses.
NOTE:
TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
NOTE:
TECHNICAL INFORMATION
Only flexible hose pipes may be disconnected.
Only flexible hose pipes may be disconnected.
- Use commercially available disconnection tools to pinch off the coolant lines.
- Use commercially available syringe (1) or a suitable tool to empty the coolant expansion tank.
- Loosen sealing cap (1).
- Suction off the coolant in the coolant expansion tank of the low-temperature coolant circuit with a conventional pump.
- Unlock lock (1).
- Pull coolant expansion tank (2) of the low temperature coolant circuit upwards slightly.
- Dispose of emerging coolant.NOTE: TECHNICAL INFORMATION
Only flexible hose pipes may be disconnected. - Unlock and loosen coolant line (1).
- Unlock and loosen coolant line (2).
- Catch and dispose of leakage coolant.
- Feed out and remove the coolant expansion tank of the low-temperature coolant circuit.