Install rear window wiper motor

• Thread the rear window wiper motor (1) through the grommet (2) and screw in a few rotations with the screws (3).
• Tighten down screws (3).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Rear wiper motor
  Torx bolt	tightening torque	7.6 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect and lock the connector (1) on the rear window wiper motor (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE TAILGATE TRIM PANEL .
• Refer to MOUNTING BOTH TRIMS FOR THE REAR WINDOW FRAME ON THE SIDE .
• Refer to INSTALLING THE TRIM FOR THE TOP REAR WINDOW FRAME .
• Refer to INSTALLING BOTH TRUNK LID COVERS .
• Refer to INSTALLING THE TRUNK LID LIGHT .
• Refer to INSTALL THE POWER TAILGATE SWITCH .
• Refer to INSTALLING WIPER ARM OF THE REAR WIPER .