Failure of the component
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
The main function of the alternator is also ensured in the event of interruption of the communication between the alternator and the engine control unit. The following fault causes are distinguishable by the fault memory entries:
- Overheating protection: The alternator is overloaded. For safety reasons, the alternator voltage is reduced until the alternator has cooled down again. That is a normal operating condition for the alternator.
- Mechanical fault: There is a mechanical block in the alternator. Or the belt drive is defective.
- Electrical fault: Defect in the excitation power circuit (transistor, diode), open circuit in the excitation coil, faulty controller.
- Communication failure: Faulty cable between engine control unit and alternator.
- Incorrect type of alternator: Incorrect or non-approved alternator installed
An interrupt or short circuit in the coils of the alternator cannot be detected.
We can assume no liability for printing errors or inaccuracies in this information and reserve the right to introduce technical modifications at any time.