63 11 550 Removing and installing/replacing the headlight driver module
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Version with xenon lighting system: Danger to life due to high voltage! Disconnect all components from voltage supply before removal.
Work on the entire xenon lighting system (ignition device, control unit and bulb) may only be carried out by qualified personnel.
Work on the entire xenon lighting system (ignition device, control unit and bulb) may only be carried out by qualified personnel.
IMPORTANT:
Observe NOTES ON PROTECTION FROM ELECTROSTATIC DISCHARGE
.
NOTE:
Headlight shown removed for purposes of clarity.
Release screws (1).
Pull headlight driver module (2) out of the headlight.
Disconnect connector (1).
Remove headlight driver module (2).
Installation note:
Ensure gasket (1) is fitted correctly during installation.
Gasket (1) must not be damaged and must be installed free from grease.
Guides must not be damaged or missing.
Replacement:
Teach in headlight driver module (1) via vehicle diagnosis.
- Service functions
- Body
- Lights
- Initialize the headlight driver module and teach in LEDs in headlight
- If applicable, carry out encoding